







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ViewLux Driveway & Pavers: The Fort Lauderdale Owner’s Guide
ViewLux driveway and paver replacement in Fort Lauderdale typically runs $7,000 – $18,000 installed, depending on square footage, paver style, and what’s hiding under the old surface. We stock ViewLux-compatible pavers and can usually start within a week of your free estimate. Most owners discover a problem the same way: a paver shifts underfoot near the garage apron, a low spot holds water after a hard rain, or the sand joints start washing out faster than they used to.

You’re likely here because one section of your ViewLux driveway isn’t holding up the way the rest is. Maybe the border course is separating from the field, or you’ve got a corner that’s sinking where the trash bins roll through every week. Whatever the symptom, the fix starts with knowing which ViewLux line you have and whether the base underneath is still doing its job. We’ll walk you through it.
Which ViewLux Models This Applies To

ViewLux paver systems generally fall into three product families: the Permeable Series (designed for drainage and often required by newer Fort Lauderdale stormwater codes), the Estate Series (thicker units, usually 60mm or 80mm, built for vehicular traffic), and the Architectural Series (thinner profiles meant for patios and walkways rather than driveways). The critical compatibility check is unit thickness and the joint pattern. A 60mm paver swapped into a driveway laid with 80mm units will sit low, shift under load, and fail within a season or two in Florida’s wet-dry cycle.
To identify what you have, look at the side of a pulled paver. Most ViewLux units carry a mold stamp on the underside or along one edge. Measure the thickness in millimeters with a simple ruler. That number matters more than the color name. If you can’t find the stamp, take a photo of the surface pattern and the paver edge, and we can identify it from our truck stock during a free estimate visit.
On the OEM-versus-aftermarket question: ViewLux-branded units are manufactured to tight dimensional tolerances, and matching those tolerances matters when you’re doing a repair rather than a full replacement. Quality aftermarket pavers exist, but they vary by manufacturer. A 1mm difference across a 20-foot run adds up to a visible wave by the time you reach the street. For patch repairs inside an existing ViewLux field, we recommend sticking with genuine ViewLux or a verified dimensional match. For full replacements, you have more flexibility and can move to other premium lines if the whole driveway is coming out anyway.
Styles & brands we work with







Signs Your ViewLux Driveway & Pavers Is Failing
- Low spots that hold water after a rain. This usually means the base layer beneath the pavers has eroded or compacted unevenly. In Fort Lauderdale, the wet season accelerates this because water finds its way through failing sand joints and washes out the bedding layer underneath.
- Edge pavers separating from the main field. The edge restraint (the plastic or concrete border that holds the outer course in place) has either cracked or pulled loose. Once the edge lets go, the rest of the driveway slowly creeps outward, and gaps widen with every car that crosses.
- Sand joints disappearing faster than a year. Polymeric sand should survive multiple rainy seasons if it was installed correctly and activated with the right amount of water. Joints that wash out in months suggest the sand was underfilled, never properly set, or the pavers are moving underneath it.
- Efflorescence or white haze that won’t clean off. Some mineral blooming is normal on concrete pavers in South Florida humidity, but persistent white crust that returns after cleaning can indicate the pavers were sealed too early or the base is holding water close to the surface.
- A paver that cracks or chips under normal car traffic. Individual pavers break when there’s a void beneath them. A good base spreads the load; a hollow spot concentrates it. One cracked paver is a symptom of the base failing directly under that point, not just a random weak unit.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For a ViewLux driveway in Fort Lauderdale, full replacement runs $7,000 – $18,000, and partial repair jobs typically land between $800 and $3,500 depending on the size of the area and how much base reconstruction is needed. What drives the number: total square footage, paver line and thickness (the Estate Series costs more per square foot than the Architectural Series), the condition of the existing base, whether we’re pulling and reusing or ordering new units, and whether the job needs a new drainage detail at the garage apron or sidewalk transition.
Every estimate we write includes the paver material, the bedding sand, the joint sand (with activation), the edge restraint, and the labor to pull, prep, and lay. You get a written number before anything starts, and that number is the invoice number, not a starting point. The work carries our 365-Day Done Right Promise: if the repair fails inside a year, we come back and make it right at no charge. That’s in writing on every job, including paver repairs that other contractors treat as too small to warrant a guarantee.
DIY or Call Us?
You can safely check a few things yourself: pull a single paver with a flat pry bar (carefully, at the edge, not with your fingers under it), look at whether the base material underneath is hard and level or soft and eroding, and check if the sand joints crumble when you run a screwdriver through them. That tells you whether you have a surface issue or a base problem.
The base problem is where DIY goes sideways. Rebuilding a compacted base correctly means removing the old material to the right depth, compacting in lifts (not all at once), and setting the slope so water moves toward the street, not toward your foundation. Fort Lauderdale’s high water table and sandy native soil make proper compaction even more important than it would be inland. A driveway that’s just a little bit soft becomes a vehicle-swallowing rut by August. If you’ve got more than a dozen pavers moving, or water pooling anywhere, call us at (754) 551-2922 and we’ll tell you honestly whether it’s a patch job or a full re-lay.
FAQs

A properly installed ViewLux driveway in Fort Lauderdale should last 20 to 30 years for the pavers themselves, assuming the base was built correctly. What usually fails first in this climate is the base, not the paver: our sandy soil and heavy seasonal rain erode poorly compacted bases within 5 to 8 years. If your driveway is failing at year 7, the odds are high we’ll find a base problem, not a paver problem, when we pull the first unit. Call (754) 551-2922 if you want an honest read on what’s under your pavers, before you spend money patching the surface.
Small areas, typically under 100 square feet with stable surrounding pavers, can be repaired by removing the affected section, rebuilding the base, and relaying matched units. If the failure spans multiple zones or the base has failed across the driveway’s full width, full replacement is the only repair that won’t telegraph the problem to the next section within a year. We’ll show you what’s underneath before we recommend anything, and the estimate is free either way.
A paver patch repair on a ViewLux driveway in Fort Lauderdale is usually completed in one to two days, including base compaction and joint sand activation. A full driveway replacement runs three to five days on most residential lots, with the final day reserved for compaction and cleanup. The pavers can be driven on the day we finish; the sand joints reach full strength within about 24 hours of activation as long as they stay dry overnight.
We keep a rotating stock of common ViewLux-compatible units on our trucks for small repairs, and for full replacements we order the exact line, color, and thickness matched to your existing field or your new design. We also stock compatible parts for KraftMaid, Cambria, and Silestone lines for our kitchen and bath clients. For ViewLux specifically, the fastest way to know what’s available for your project is to send us a photo of the existing paver surface and edge, and we’ll identify it from our inventory records before we even set foot on your property.
If your ViewLux driveway is failing, don’t wait for the next heavy rain to make it worse. Call (754) 551-2922 and we’ll give you a straight answer on what it costs to fix, written down, before any work starts. Tell me what you need, I’ll tell you what it costs – then we’ll get it done.
Written by Trevor Nash, Owner, Penhallow Remodeling Fort Lauderdale at Penhallow Remodeling Fort Lauderdale, serving Fort Lauderdale and nearby areas.


