Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Jerith Fence Installation: The Fort Lauderdale Owner’s Guide
Jerith fence installation in Fort Lauderdale typically runs $3,500 to $9,000 for a complete property installation, depending on linear footage, gate count, and soil conditions. If you’re dealing with a failed section, post, or gate rather than a full install, the work usually lands on the lower end as a repair and we can often get it done within a week of your call to (754) 551-2922. You’ll know something’s wrong when the gate starts dragging on the concrete, a panel leans after every afternoon storm, or the latch no longer lines up with the post receiver.
Jerith is a specific beast. The aluminum gauge, the powder-coat chemistry, the gate hardware spacing, it’s all engineered to a tolerance, and South Florida’s salt air plus our daily summer downpours find every weak spot within a few seasons. We’ve taken apart enough Jerith sections across Fort Lauderdale to know exactly what fails first and what it takes to put it back so it stays put.
Which Jerith Models This Applies To
Jerith’s residential line breaks down mostly by picket style and gate configuration. The two Fort Lauderdale homeowners call us about most are the Regal series and the Vintage series. Regal is the straight-picket aluminum panel with the spear-top option; Vintage is the bow-top design most common around Victoria Park and Rio Vista homes built in the 90s and early 2000s. If your fence runs a scalloped or arched top, you’re almost certainly looking at Vintage panels.
How to identify what you have without a manual: look at the bottom horizontal rail. Jerith stamps older Regal panels with a four-digit die code on the underside, usually starting with an R or V. Newer panels have a small aluminum manufacturer tag riveted near the hinge side. Measure your picket spacing too, that’s the gotcha. Classic Regal uses 3-7/8 inch on-center spacing; Vintage uses 3-1/2. Buy the wrong panel width and you’ll spend a weekend shimming it into a reveal that was never going to fit. We stock factory-match panels for both series on the truck.
One thing worth saying up front: Penhallow Remodeling Fort Lauderdale is an independent service provider. We install and repair Jerith-compatible fence systems, but we’re not a Jerith dealership, and we’ll tell you honestly when a cosmetic aftermarket panel serves you better than paying OEM freight on a 12-year-old fence line.
Styles & brands we work with
Signs Your Jerith Fence Installation Is Failing
- The gate hangs low and scrapes. This is almost always failed hinge screws or a hinge post that’s started to drift. In Fort Lauderdale’s sandy coral soil, a post set in a shallow concrete footer will tilt a quarter inch per year until the gate binds.
- Panels rattle in wind or after a push. Jerith panels are decently rigid; looseness means the self-tapping screws at the rail brackets have stripped or the rail has slipped out of its channel.
- White chalky film on the rails. That’s the powder coat oxidizing. It’s cosmetic initially, but once the aluminum is exposed near the salt line (anything within two miles of A1A), pitting follows and panels weaken at the joints.
- Latch won’t catch or opens on its own. Usually the gate frame has racked slightly out of square. The fix is re-shimming the hinge plates, not just adjusting the striker.
- Posts lean toward the house side. Concrete collar is crumbling or was never flared. Once a post leans past 5 degrees, it’s a re-set, not a brace job.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what we quote in Fort Lauderdale, in writing, before any work starts.
- Full property install (120 to 180 linear feet): $3,500 to $6,500 for typical Regal or Vintage styles, one pedestrian gate included.
- Full install with two gates or a wider lot: $6,500 to $9,000, driven by gate hardware, double-drive gates, and post spacing through root-heavy yards.
- Section or panel repair (three to five panels): $850 to $2,200, depending on access and whether the rails need to be re-sleeved.
- Gate replacement only (standard 4-ft pedestrian): $1,100 to $2,400 installed, including new hinges and a latch assembly.
Every quote includes the panel or gate hardware, fasteners, concrete footer work, and haul-away of the old section. The number on day one is the number on the invoice. Fort Lauderdale yards bump the range when there’s irrigation piping near the post line or live oak roots that have to be worked around without damage.
DIY or Call Us?
You can absolutely check a few things yourself before spending money. Look at the hinge screws; if they’re loose, tighten them and see if the gate re-lifts. Look at the post caps; if they’re missing, water has been filling the post and that’s a structural issue you should not ignore. Wipe a suspicious white spot with vinegar; if it darkens and stays chalky, it’s oxidation, not dirt.
Where DIY goes wrong with Jerith in particular is post setting. Jerith bottom rails need a minimum 2-foot concrete footer with a flared base below the frost zone; there isn’t a frost zone here, but our water table in neighborhoods like Shady Banks and Sailboat Bend sits about 3 to 4 feet down in rainy season. Set a post in a shallow, narrow hole and the first tropical storm pulls it right over. If you’ve got a leaning post or a gate that won’t shut, call (754) 551-2922 and we’ll come look before you’ve bought the wrong sack of concrete.
FAQs
A properly installed Jerith aluminum fence in Fort Lauderdale lasts 20 to 30 years; the powder coat degrades faster within two miles of the ocean, where salt spray shortens the finish life to 12 to 18 years. The posts are what fail first, not the panels. Call (754) 551-2922 and we’ll tell you what stage your fence is in.
Yes, in most cases. Single panels, gate hardware, hinges, and even re-set posts can all be repaired without replacing the full run, provided the rail extrusion is still intact. We’ll always price the repair next to the replacement so you can see the real numbers.
A section repair usually takes a single day on site; a full property installation in Fort Lauderdale runs 2 to 4 days, including concrete footer curing time and gates. We’ll give you a defined arrival window and tell you what to expect before the crew shows up.
We carry factory-match Regal and Vintage panels for the common 4-ft and 6-ft heights, plus hinge kits, latch assemblies, and post caps. If your panel is a discontinued series, we source OEM-equivalent fabrication locally in Broward County, usually within 3 to 5 business days.
No. The written price we give you is the price you pay. The only thing that changes a number is if we open the ground and find something we agreed to address, at which point we stop and talk to you first, with a new written number.
Tell me what you need, I’ll tell you what it costs, then we’ll get it done. Call (754) 551-2922 and we’ll schedule a free estimate for your Jerith fence installation in Fort Lauderdale.
Written by Trevor Nash, Owner, Penhallow Remodeling Fort Lauderdale at Penhallow Remodeling Fort Lauderdale, serving Fort Lauderdale and nearby areas.
