Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Fence Installation: The Fort Lauderdale Owner’s Guide
Mr-Glass fence installation in Fort Lauderdale typically runs $3,500 – $9,000 for a full panel system, depending on linear footage, gate hardware, and whether we’re pulling out an old failed frame or starting fresh. We install Mr-Glass-compatible fence systems and keep common replacement parts in our Fort Lauderdale inventory so most swaps happen within one visit.
Most owners discover the part failed the same way: a panel sags by late afternoon, a gate starts dragging against the pavers, or a corner post twists just enough that the latch stops catching. You’re probably reading this because something’s already visibly wrong. That’s the time to fix it, not wait out another South Florida summer of salt air and afternoon storms.
Key Takeaways
- Installed Mr-Glass fence work in Fort Lauderdale: $3,500 – $9,000, written price before we start
- We’re an independent installer, not a Mr-Glass corporate affiliate
- Salt air and sandy soil cause most Fort Lauderdale fence failures, not manufacturing defects
- Every repair or install carries our 365-Day Done Right Promise in writing
Which Mr-Glass Models This Applies To
Mr-Glass fencing covers a few distinct lines, and the part you need depends on which one you own. The most common in Fort Lauderdale are the Mr-Glass Infinity glass panel system (frameless panels with stainless steel spigots) and the Mr-Glass framed system, which uses aluminum posts and channels. We also see the occasional Mr-Glass gate kit attached to an existing masonry wall. The Infinity and framed systems share almost no hardware, so matching the right part starts with identifying your line.
Look for the small etched logo in the lower corner of a glass panel, or check the original paperwork if you still have it. The spigot spacing tells you more: Infinity panels sit on base shoes spaced 16 to 24 inches apart, while framed panels slide into side channels with a bottom U-channel. When it comes to replacement hardware, OEM Mr-Glass parts are the surest fit, but in our experience Fort Lauderdale homeowners often get better longevity from marine-grade 316 stainless aftermarket spigots and handles, because the OEM 304 hardware can pit within five to seven years this close to the ocean. We stock both and will tell you which we’d pick for your exact exposure before you spend a dollar.
Styles & brands we work with
Signs Your Mr-Glass Fence Installation Is Failing
- Glass panel leaning or slightly out of plumb. This usually means a spigot has loosened in the concrete footing, or the rubber gasket inside the base shoe has compressed and let the panel drift. Tightening alone rarely holds; the gasket usually needs replacement.
- White chalky residue or pitting on metal hardware. Salt air in Fort Lauderdale eats 304 stainless faster than most people expect. Pitting on a spigot or hinge means the part is degrading from the outside in and will eventually snap under load.
- Gate dragging or not latching cleanly. Sandy soil settles, and a gate post that’s shifted even a quarter inch throws the hinge geometry off. The latch might be fine; the post footing is usually the actual problem.
- Hairline crack running from a corner of a glass panel. Tempered Mr-Glass panels are tough, but a crack that starts at a pressure point, usually a misaligned spigot or a rusted shim, will spread. That panel needs replacement, not repair.
- Banging or rattling during wind. Frameless Infinity panels are designed to flex slightly in high gusts, but persistent rattling means the rubber isolators are gone or the base shoes have loosened. Fort Lauderdale summers push enough wind that a loose panel can become a real hazard.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
A full Mr-Glass fence installation in Fort Lauderdale runs $3,500 – $9,000. A partial replacement, say swapping three failed panels and the matching gate, tends to land around $1,800 – $4,200 depending on what’s salvageable. The spread comes down to panel size (tall panels and wide gates cost more), footing work (sandy soil sometimes needs deeper concrete pours), and whether we’re matching existing hardware or replacing the whole run.
Every quote includes the parts, the labor, the concrete footing work, haul-away of the old material, and our written guarantee. You get a line-item price before we start. If the gate sags or a spigot fails inside 365 days, we come back and make it right at no charge under the 365-Day Done Right Promise, and there’s never a service fee for a return visit.
Fort Lauderdale Mr-Glass Fence Pricing
- Partial panel replacement: $1,800 – $4,200
- Full fence installation: $3,500 – $9,000
- Gate only (post, frame, hardware): $900 – $2,800
- Spigot/hardware swap per panel: $180 – $450
DIY or Call Us?
A homeowner can do a few useful checks: tighten visible spigot bolts, clean salt residue off aluminum channels, look for cracked rubber isolators. That’s about it. Glass fencing is not like a wood fence where you can shim a post and call it done. The panels are heavy tempered glass, the hardware sits under tension, and a panel that slips during removal can injure someone fast.
We’ve also seen what happens when a homeowner uses zinc-plated hardware from a big-box store on a salt-exposed fence: it rusts in under a year and the panel sags again. If you want to try small adjustments yourself, we’ll talk you through it over the phone. If the post is leaning or the glass is cracked, call (754) 551-2922 and we’ll bring the right parts.
FAQs
Glass panels themselves last 20+ years. The hardware is the weak point. Near the ocean, expect 5 – 10 years from spigots, hinges, and handles before salt corrosion forces replacement. Inland Fort Lauderdale, somewhere like Plantation or Davie, hardware typically goes 10 – 15 years. We can replace just the hardware and keep your existing panels. Call (754) 551-2922 and we’ll assess what’s actually worn.
No. Mr-Glass panels are tempered safety glass; once cracked, they can’t be repaired. The good news is the surrounding hardware often survives, so you may only need one new panel and fresh gaskets, not a whole new section. We stock common panel sizes in Fort Lauderdale to keep the repair to one visit.
A partial replacement usually takes one day. A full fence installation with new footings takes two to three working days, most of which is concrete curing time. Fort Lauderdale’s sandy soil sometimes requires slightly deeper footings, which can add a day. We give you a written timeline with the quote so there’s no guessing.
We carry common Mr-Glass spigots, gaskets, handles, and aluminum channels in our Fort Lauderdale inventory. For less common Infinity panel sizes or custom gate hardware, we order directly and typically have the part within three to five business days. Tell us what you need, we’ll tell you what it costs, then we’ll get it done.
If your Mr-Glass fence is leaning, cracked, or dragging, call (754) 551-2922 for a free estimate. We’ll give you a written price before any work starts, and it’s the same number on the final invoice. No surprises, no pressure, just the fence done right.
Written by Trevor Nash, Owner, Penhallow Remodeling Fort Lauderdale at Penhallow Remodeling Fort Lauderdale, serving Fort Lauderdale and nearby areas.
